“I found the training to be of great value. Our initial discussions on foundational plastic flow characteristics, pressure drop, shear rate, Reynolds number and MFI vs. Capillary Rheometer curves led the way.
Then the lab exercises, discussions on viscosity, Steel/shear imbalances and processes to use during mold start-up finished it off. I got a lot of good information that can immediately be put to use.”
Kevin Morris, Project Tooling Engineer
Innovative Injection Technologies
“Of all the training seminars that I have attended over the past 10 years, this one ranks at the top! The explanations of clamp tonnage, cooling strategies, viscosity, and key mold design components are just a few of the takeaways that will be very useful in my job function.”
“I was amazed at the amount of expertise and knowledge presented in just two days. Many myths were debunked, numerous scientific explanations for the way we should be thinking about plastic flow were given, and various real-world examples were used to show how plastic flows.”
